Tip: Improve high-frequency response of your diferential probe above 10MHz

Welcome to our Forum, extension and content sharing platform of Electrical Test and Measurement Product Reviews Blog.

Registration this is Free, we accept contributors of 17 years old and above. We do not accept registration with Gmail

Active since 7 June 2012

Copyright Notice: Entire ITTSB.EU content & images they are copyright protected. - Forum search engine disabled to Guests - No need of you using Adblock software.

(1/1)

Kiriakos GR:
This suggestion came from a new diferential probe manufacturer in China.

The sugestion talks about input line winding, so you can better eliminate noise and improve the ability of high-frequency response.

So far the most know sugestion for a high bandwith diferential probe is to keep the test lead wires in to a minimum length of 60cm.

Check the image below and feel free to use this new tip at your benefit. ;)

Navigation

[0] Message Index

ITTSB.EU Blog

General Data Protection Regulation GDPR ITTSB.EU Home Page Reward us by a Donation - Sponsorship TsDMMViewer Data Logger for FLUKE 884xA

ITTSB Blog - Sponsors

protosnet.com - Internet solutions FLUKE benchtop DMM Repair Services